Ultimate process reliability at uniformly and clean application of lubricants even with the smallest dosing volumes. This Spray Valve AXDV-C-SPK allows for controlled spraying of the lubricant volume defined by the Volumetric Metering Valve, independently from the viscosity, operating pressure and time. This allows accurate precisely placing of minute quantities of your complex lubricant on your device.
Thanks to every spray cycle with exactly the same amount of grease or oil (high repeatability), means permanent saving of your expensive lubricant!

There are no pre or dripping drops in this Spray Valve. Due to ist special shape, the grease piston, triggers a retraction effect at the end oft he spraying process, which causes the lubricant to tear off cleanly. Nozzle and production area remain clean, the lubricant is optimally utilized. The downtime to clean the assembly line are thereby minimized.

Sensors to monitor the position of the grease piston may be retrofitted at any time. They increase the effectivity and reliability of the spraying operation, and allow improved control over your production and assembly process!

The electronic position switch is available as accessory, Art.No. 0001220. It may be attached to the grooves of the Metering Valve by means of an attachment screw in a continuously variable position. Furthermore, the operation display (LED) indicates the end position of the grease piston. To achieve highest process reliability, ABNOX recommends the use of position switches on both end positions.

The Volumetric Spray Valve has a continuously screw-adjustable dosage chamber, as well as an integrated pneumatic cylinder to control the Spray Nozzle.

A hexagon key wrench with hex. 1.27 mm for the series C1/C2 and with hex. 2.00 mm for the series C3/C4 (included in scope of supply) is used to lock the adjustment screw. Accidental misadjustment of the dosage volume is therefore a matter of the past.

For external control for the Spray Valves with Assembly Block, a simple Pneumatic 5/2-way Valve is required.

On the Spray Valves with Handle (models PN/HG), the pneumatic part of the Spray Valve is controlled by a 5/2-way Valve which is located inside the Handle. Pressing the trigger initiates ejection of the metered medium and is simultaneously the spraying. The output pressure depends on the lubricant feed pressure (media). The pneumatic system is separated from the grease chamber.

ABNOX Spray Valves with Handle (models PN/HG) are especially suitable for all accessible lubrication points. The ergonomic and shapely Handle with modern and optimised metering activator is especially suited for easy and handy operation of the Metering Valve at installation sites. Handling of these Spray Valves may be further facilitated by using a counterbalance suspended directly above the assembly area.

All ABNOX Spray Valves are equipped with modern seals and glydrings, they warrant a long lifespan even at operating pressures as high as 200 bar.

Besides Metering and Spray Valves for various dosage volumes, ABNOX provide suitable Conveyor Pumps and ancillary equipment for complete solutions to your lubrication process. With the Spray Nozzles SPK ABNOX Ltd. constructs specific customised application Spray Nozzles which can be directly screwed to Metering and Spray valve.